Electric Awning Windows - PREVOST H3-41 Maintenance Manual

NOTE
Do not stretch plastic film and leave enough
play to be able to push window out without
tearing the plastic film.
o Using a ball peen hammer, hit one of the
window bottom corners from the outside.
Carefully push window out and lift it up
o
sufficiently to
aluminum molding.
o Attach the windshield wire to a fish wire
and thread it underneath the aluminum
molding behind the rivets.
o Detach wire from fish wire and continue
cutting using the handle.
o Make a notch at each window top corner
to make sure you pass underneath the
remaining pieces of glass.
o Remove the aluminum molding and clean
up the frame using the window scraper.
For gluing of lateral fixed window behind driver,
refer to procedure SAV00046.
For gluing of lateral fixed half-window, refer to
procedure SAV00045.
For the installation of awning or sliding window,
refer to procedure SAV00038.
For gluing of lateral fixed window, refer to
various procedures: SAV00037 for g
and bottom rubber seals
installation of lateral
SAV00044 for making the Simson joint around
fixed windows.

10.2.3 Electric Awning Windows

The electric awning windows are connected
directly on the batteries 24 V DC terminal block.
As a result, they can be operated regardless of
the state open or close of the master switch.
Window Removal
Replacement awning window does not include a
new motor. If in working order, transfer the motor
of the replaced window to the replacement
window. If not, the motor can be bought
separately. When replacing the window, keep
the components in working order as spare parts.
separate it from the
luing vertical
; SAV00043 for the
fixed window and
1. Push the vertical latch handle downwards to
release the track and then open the window
using the horizontal latch handle.
2. Take out the screw at the lower end of the
track to let free the swiveling arm roller.
3. Unplug connectors. Dismount the gas spring
from the window.
4. Loosen the set screws #5 (Figure 104)
(rotate the arm to get to the second set
screw) and disengage the swiveling arm
from the motor shaft extension.
5. Push the glass window out ninety degrees
(90°).
CAUTION
The window may fall out.
6. The window is free and can be unhooked.
7. Reverse procedure to install a new one.
PA1621 Maintenance Manual All Series | Revised Sept 2019
SECTION 18b: X3 SERIES BODY
115