PREVOST H3-41 Maintenance Manual page 823

9. Close door to center the latch assembly.
10. Tighten the receptacle screws only.
11. .Door exterior panel on latch side should be
positioned at 8mm +1mm from frame. Make
the adjustments by moving the receptacle
support.
12. Make sure that backing plate is parallel to
structure before tightening the retainer
support hardware
13. Make sure that skid bar only touches slightly
bus structure at bottom. The door should not
move up when closing.
14. Check that the door swings freely and
closes properly.
PA1621 Maintenance Manual All Series | Revised Sept 2019
SECTION 18b: X3 SERIES BODY
139