PREVOST H3-41 Maintenance Manual page 681

4.00 Remove fiberglass from structure using a
screwdriver. Use wedges if necessary to hold
down panel during the work.
4.05 Remove as much glue as possible. If primer is
removed, apply primer 206 G+P locally. If
primer is OK, reactivate as per SAV000001
section D.
4.10 Apply Ultrafast 2 glue (heated).
4.15 Compress panel using clamps and a metal flat
bar (for an even compression). Only use screws
as a last resort to compress.
4.20
Vehicle must not move for the next 12
hours.
37. REAR VIEW MIRRORS (RAMCO)
Your vehicle is equipped with two exterior
mirrors.
The mirrors may be equipped with an optional
electric heating system which serves to minimize
ice and condensation on the mirror glass in
extreme weather conditions. Integral thermostats
are installed in both mirrors to avoid continuous
heating. Use the appropriate switch on the
dashboard to activate the defroster system on
both mirrors simultaneously. The mirrors can
easily be adjusted by using the remote controls
located on the L.H. side control panel. The
mirrors have easy to replace glass in case of
breakage. Remote control motors can also be
replaced.
MIRROR
HEAD
FLAT
MIRROR
CONVEX
MIRROR
FIGURE 78: REAR-VIEW MIRROR (RAMCO)
SECTION #3 REPAIR
CONVEX
MIRROR
POSITION BALL CUP
HALVES SO THE JOINT
BETWEEN THEM LIES ON THE
CENTER LINE OF THE ARM.
ENSURE THAT THE SETSCREWS
ARE NOT ON THE JOINT BETWEEN
THE CUP HALVES.
18201
PA1621 Maintenance Manual All Series
SECTION 18a: H3 SERIES BODY
37.1 ADJUSTMENT
At the base of the mirror arm, loosen the
mounting bolt to swing arm in or out.
To pivot the mirror head, loosen the setscrews
on each side of the ball stub at the base of the
mirror head to facilitate the adjustment.
37.2 DISASSEMBLY
At end of mirror arm, loosen the setscrews to
relieve tension on the ball stem. Remove the ball
stem from the arm.
Remove the four screws fastening the mirror
arm base to the coach.
37.3 ASSEMBLY
Mount the mirror arm base to the coach.
Insert the ball stem into the mirror arm and
tighten the socket setscrews.
NOTE
Position the ball cup halves so the joint
between them lies on the centerline of the arm.
Ensure that the setscrews are not on the joint
between the cup halves.
37.4 REPLACEMENT OF MIRROR GLASS
Remove the broken glass.
Position new glass in mirror head and press to
lock the Velcro in place.
|
Revised Sept 2019
77