PREVOST H3-41 Maintenance Manual page 147

• Remove the
separator and move them out of the
way.
FIGURE 24: CIRCUIT BREAKER BOX CONNECTIONS
4. Remove the shroud upper and lower hold
down screws and open the shroud assembly
(yellow handle).
FIGURE 25: SHROUD HOLD DOWN SCREWS
wires from the wire
PA1621 Maintenance Manual All Series
SECTION 05: COOLING SYSTEM
5. Unfasten the limiter strap at the bottom of
the shroud assembly.
6. Support the bottom of the shroud assembly
with a lift table or other suitable equipment.
7. Unscrew the shroud upper hinge at the
vehicle structure and remove the hinge.
NOTE
It is good practice to scribe the hinge position
on the vehicle structure to use as a reference
point upon reinstallation. This will minimize the
need for hinge adjustment.
8. Slightly lift the door with the lift table to
disengage the lower hinge pin and allow
shroud removal from the vehicle.
NOTE
Do not lose the plastic bushings installed at
the pivot point of both lower and upper hinges.
9. Reverse removal procedure to reinstall the
fan shroud assembly making sure that;
• The bushings are installed at the hinges
pivot point.
• There is no gap at both hinges between
the bushing and the hinge pivot.
• Main connectors are fully engaged (paint
mark are aligned).
FIGURE 26: INSTALLED HINGE & MAIN CONNECTOR
|
Section 05 revised Feb 2019
27