Front Steps Replacement Procedure - PREVOST H3-41 Maintenance Manual

SECTION 18a: H3 SERIES BODY

14.1 FRONT STEPS REPLACEMENT PROCEDURE

MATERIAL
Part No
682989
683097
685101
683916
684654
684655
684517
1. Cut and remove damaged step(s).
2. Remove dirt and adhesive residue.
NOTE
In wintertime, condensation and cold temperature may greatly influence bonding parameters. Working
area must be at a temperature sufficient to prevent reaching condensation point. Mechanically preheat
working area (heat lamp or heat gun) or wait until vehicle reaches room temperature.
PREPARATION OF "TARABUS" FLOOR COVERING
1. Sand under step using "Scotchbrite".
2. Clean using anti-silicone (refer to Section A).
Section A Alcohol or Anti-silicone
3. Allow drying
Mandatory
Before applying any other
product
3. Apply Sika Primer 215 (refer to Section D).
36
PA1621 Maintenance Manual All Series
Anti-silicone
Sika 205 (1 liter)
Sika Remover 208
Sika 215 (1 liter)
Adhesive, Contact (3M)
Adhesive, Contact (3M)
Sealant, gray
1.
Apply
CHIX cloth
Minimum time : Wait for product to evaporate
After 2 hours: Start cleaning operation again
If surface seems dusty, greasy or with finger marks, start cleaning
operation again.
|
Revised Sept 2019
Description Qty
A/R
A/R
A/R
A/R
3.8L
18.9L
A/R
2.
Dry immediately
Blue cloth