Zone 7; X3 Smooth Side Panel Replacement Procedure - PREVOST H3-41 Maintenance Manual

9.7 ZONE 7

FIGURE 84: ZONE 7
9.7.1

X3 Smooth Side Panel Replacement Procedure

Material:
Anti-silicone (682989)
CHIX cloth (682384)
Blue cloth (682383)
Equipment:
Glue gun
Pencil
1.00
A) Remove finishing molding. Insert a screwdriver into
snap-on finishing molding joint. Bend finishing
molding enough to be able to fix a pair of locking
pliers. Using the pair of locking pliers, pull the
stainless steel molding and at the same time
gradually cut Sika bead with a sharp knife.
B) Using a hammer and punch, drive out rivet shanks
from top and bottom and from front and rear finishing
molding supports. Use a #11 titanium drill bit to
remove rivet heads.
Scotchbrite gray (680226)
√
Sika 205 1liter (683097)
√
√
√
√
SECTION 1 SMOOTH SIDE PANEL REMOVAL
REMOVAL
PA1621 Maintenance Manual All Series | Revised Sept 2019
SECTION 18b: X3 SERIES BODY
Sika 221 gray
√
Sika 252 black
√
Be careful not to damage the adjacent
surfaces.
18630
√
√
83