PREVOST H3-41 Maintenance Manual page 959

MOUNTING THE CLUTCH ON THE COMPRESSOR
PREPARATION
1) The flange and the shaft end must be free
from dirt.
2) Apply high temperature
assembly grease on the shaft end for easy
dismounting of the clutch.
Use of Molykote G-rapid-plus or Molykote
P 40 is recommended
INSTALLING THE COIL
3) Reinstall the coil. Slip the coil on the
compressor flange. The cable connector
must be positioned on the right side as
shown on the image.
4) Fasten the four M8 screws by hand to the
compressor and then apply final torque.
Coil mounting screws: 22 lbf-ft (30 N-m).
Use blue Loctite 243.
Caution: Pay attention to the precise seat of
the coil. A non-observance may cause the
destruction of the clutch components during
operation.
Writer:
EL
approved
PROPER CABLE CONNECTOR POSITION
MI18-37
Page 7 / 14
<QF7720955 rev 7>