Entrance Door (V.i.p); Keyless Entry System; Door Adjustment; Horizontal And Vertical Adjustments - PREVOST H3-41 Maintenance Manual

11. ENTRANCE DOOR (V.I.P)

There are three ways of unlocking the entrance
door from the inside of vehicle. The two first
consist in actuating the rocker switch on the
dashboard, but this last operation will also unlock
the baggage compartments. Finally, you can
unlock the door by sliding its lock lever to the left.
If the orange tab on the door lock lever is visible,
the door is unlocked.
You may lock/unlock the entrance door from the
outside with the lock key provided with the
vehicle. Turn key CCW to lock and CW to unlock
the entrance door.

11.1 KEYLESS ENTRY SYSTEM

With this system, you can lock or unlock the
entrance door as well as the baggage and
service compartment doors.
located below the entrance door handle. The
module is pre-programmed by the manufacturer
and this code can not be deleted. Moreover, you
can program your own entry code. Refer to the
"VIP Owner's Manual" for instructions on how to
program your own entry code.
When you use the keyless entry system, the
keyboard and stepwell lights illuminate. Do not
push the buttons with a key, pencil or any other
hard object as it could damage the buttons.
Although each button is provided with two digits
separated by a vertical line, there is only one
contact per button. Always press the center of
the button (between the two digits, on the vertical
line).
If you let more than five seconds pass between
each button press, the system shuts down, and
you have to enter your code again. If the keyless
entry system does not work properly, use the key
to lock or unlock entrance or compartment
doors. To know more about the keyless system,
refer to the "VIP Owner's Manual".
NOTE
You must unlock the entrance door before you
unlock with the appropriate key any baggage
or service compartment doors.

11.2 DOOR ADJUSTMENT

Check around the perimeter of the door for
binding. If any binding is found, adjust as
follows:
The keyboard is
PA1621 Maintenance Manual All Series
SECTION 18a: H3 SERIES BODY

11.2.1 Horizontal and Vertical Adjustments

1. Remove the screws and the plastic molding
covering each of the hinges.
NOTE
Ask an assistant to help you to perform the
following adjustments.
HINGE
HORIZONTAL BOLTS
FIGURE 20: ENTRANCE DOOR (VIP)
2. Support the door with a wooden block and a
hydraulic jack.
3. Loosen the horizontal bolts retaining the
door to the hinges. Adjust the door
horizontally and vertically with the jack.
Tighten the bolts to
TORQUE: 55-65 lb-ft (75-88 Nm)
Remove the jack and the wooden block.
4. Check door fit.
5. Using the screws, fasten the plastic trim to
cover the hinges.

11.3 DEPTH ADJUSTMENT

To adjust door depth on the hinged side:
1. Remove the screws and the trim covering
each of the hinges.
NOTE
Ask an assistant to help you to perform the
following adjustments.
2. Slightly loosen, but not completely the
vertical bolts on both door hinges.
3. Ask your assistant to press the door from the
exterior, until it will adjust with the vehicle
structure. Then, tighten the vertical bolts.
4. Repeat step 3 until depth is corrected to
satisfaction.
|
Revised Sept 2019
VERTICAL BOLT
PLASTIC MOULDING
SUPPORT
18058VIP
29