PREVOST H3-41 Maintenance Manual page 679

B) At the rear, adjust panel height so that it
is level with rear cap
C) Gap between lateral panel and rear cap
must be 6mm +4/-3 and panels must be
aligned within 1.5mm.
D) Using a ruler, adjust front of lateral panel.
E)

Verify if panel upper corner is in
the middle of window post.
1.55 Remove excess of glue using a spatula.
Apply a bead of Sika 252 at the top of panel
Spray pure water onto all the joints to speed
up drying process
1.60 Remove protective tape (installed at step 1.10b).
PA1621 Maintenance Manual All Series
SECTION 18a: H3 SERIES BODY
|
Revised Sept 2019
75