PREVOST H3-41 Maintenance Manual page 678

SECTION 18a: H3 SERIES BODY
C) Apply 206 G+P onto structure.
See SAV000001 section D.
1.15 Seal entrance door perimeter using Sika 252
black,
Smooth down the excess.
Install lateral panel supports onto bottom
1.20
structural tubing. Install lateral panel onto
supports to verify proper positioning.
1.25
Glue application
Set (timer) or record time.
A)

No more than 45 minutes should
elapse between beginning of glue
application and panel installation.
Apply Sika 252 black onto structure
B)
1.30 A) Install lateral panel onto supports and
* clamp panel in place using "C" clamps
and square tubing to even out the
pressure.
Note: A maximum of clamps should be
used (every 6 inches) to ensure proper
bonding. Do not tighten too much.
74
PA1621 Maintenance Manual All Series
|
Revised Sept 2019