PREVOST H3-41 Maintenance Manual page 723

Apply Sika 255 onto door frame structure.
•
Note: Leave some
space at the bottom
(50mm) for water
dripping.
Install and center fiber glass body panel onto
•
door frame leaving an excess of 3mm all
around the frame.
Line-up body panel with window. There must
•
be a gap of 4±2mm between window and
body panel.
Apply some masking tape 1mm from
•
window edge and body panel.
Fill the gap between window and body panel
•
with Sika 255.
Smooth down the joint with a plastic scraper
•
then remove masking tape.
Wet Sika joint using water to accelerate the
•
curing process and put the finishing touch
with your finger.
Discard
•
environmental regulations, use dangerous
waste containers.
PA1621 Maintenance Manual All Series | Revised Sept 2019
SECTION 18b: X3 SERIES BODY
waste according to applicable
39