PREVOST H3-41 Maintenance Manual page 760

Hide thumbs Also See for H3-41:
Table of Contents

Advertisement

SECTION 18b: X3 SERIES BODY
Carefully install panel onto support structure.
Evenly distribute and install conforming weights
(6 to 8) (80 to 100 lbs total) onto panel for at
least 4 hours. Make sure panel does not move.
Finishing Joints
In the case of lateral finishing joint, apply some
masking tape ¼" from panel edge and ¼" above
panel.
In the case of front finishing joint, apply some
masking tape on each side of joint.
Clean with anti-silicone the area where the
Simson glue will be applied.
76
PA1621 Maintenance Manual All Series | Revised Sept 2019
Apply some Simson glue to fill the gap.
Front finishing joint
Section 2
Flat joint in front of fuel tank access panel
Use plastic spatula #682838 to perform radius
Rear baggage compartment equipped with WCL

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

H3-45H3-45 vipX3-45X3-45 vip

Table of Contents