SECTION 18b: X3 SERIES BODY
12. Close the door gently.
FIGURE 64
13. Open the door and perform a final tightening
to the items indicated with arrows (FIGURE
65).
FIGURE 65
Transversal adjustment
14. Once closed, the door surface must be even
with the adjacent steel panel.
Tolerance is 3/64" (1mm)
62
PA1621 Maintenance Manual All Series | Revised Sept 2019
FIGURE 66: USE A RULER (SHOWN IN BLACK) TO
CHECK THAT SURFACES ARE EVEN
15. Use the pin to adjust the door so it is even
with the adjacent panel. Screw or unscrew
the pin as required and then apply final
tightening to the jam nut (FIGURE 67).
FIGURE 67
16. The R.H. side engine access door must
exceed the engine compartment by 5/32"
(4mm).
Tolerance is ±3/64" (±1mm)
FIGURE 68