Entrance Door; Front Electrical & Service Compartment Door; Upper Lateral Window - PREVOST H3-41 Maintenance Manual

SECTION 18b: X3 SERIES BODY

10.1.6 Entrance Door

For the removal of entrance door body panel,
you will need:
Pneumatic hammer tool (Zip Gun);
Razor sharp window scraper;
o Before removing body panel, you can to
ease repair uninstall entrance door from
vehicle. If applicable, remove reflector,
keyless system keyboard and cornering
light.
You must also remove horizontal finishing
o
molding located underneath the window.
This molding is glued and will have to be
replaced because it will be damaged at
removal.
o Remove interior finishing panel to access
rub rail fixing bolts, then remove rub rail.
Using the "Zip Gun", cut Sika bead
o
located ¼ inch (7-8 mm) from each body
panel edge and around cornering light.
Separate body panel from door.
o
o Remove from door surface Sika bead and
double-face self-adhesive tape residue
using a razor sharp window scraper.
Use a Chix cloth and anti-silicone to
o
remove any dust or residue.
For assembly, gluing or finishing joints of
entrance door, refer to procedure SAV280020 .
For gluing of entrance door horizontal finishing
molding, refer to procedure SAV00213 .
For the installation of entrance door, refer to
procedure SAV280022.
10.1.7 Front Electrical & Service
Compartment Door
For the removal of front electrical & service door
body panel, you will need:
Pneumatic hammer tool (Zip Gun);
Razor sharp window scraper;
o Before removing body panel, you can to
ease repair uninstall front electrical &
service door from vehicle. If applicable,
remove reflector and cornering light.
o You must also remove horizontal finishing
molding located underneath the window.
112
PA1621 Maintenance Manual All Series | Revised Sept 2019
This molding is glued and will have to be
replaced because it will be damaged at
removal.
o Remove interior finishing panel to access
rub rail fixing bolts, then remove rub rail.
Using the "Zip Gun", cut Sika bead
o
located ¼ inch (7-8 mm) from each body
panel edge and around cornering light.
o Separate body panel from door.
Remove from door surface Sika bead and
o
double-face self-adhesive tape residue
using a razor sharp window scraper.
o Use a Chix cloth and anti-silicone to
remove any dust or residue.
For assembly, gluing or finishing joints of front
electrical & service compartment door, refer to
procedure SAV280021.
For gluing of driver's window, refer to procedure
SAV290013.
For gluing of front
compartment door horizontal finishing molding,
refer to procedure SAV00213.
For the installation of front electrical & service
compartment door,
SAV280022.

10.1.8 Upper Lateral Window

For the removal of driver's window or upper
lateral window, you will need:
Pneumatic hammer tool (Zip Gun);
Razor sharp window scraper;
"Olfa" knife;
Face shield.
In the case of driver's window only, open
o
front service compartment door.
Mark the position of the driver's window for
o
future reference.
From inside of vehicle, cut Sika bead
o
around window perimeter using a "Zip gun"
while another person hold the window from
the outside.
NOTE
Wear ear plugs during this operation.
electrical & service
refer to procedure