PREVOST H3-41 Maintenance Manual page 340

SECTION 07: TRANSMISSION
FUNCTION
PID/SID
the
temperature
of the
gearbox oil
(SETeGO
Sensor for
the
temperature
of the
gearbox oil
(SETeGO
Sensor for
the
temperature
of the
gearbox oil
(SETeGO
Sensor
position of
the clutch
PID33
(SEPoC and
SEPoCINV)
56
PA1621 Maintenance Manual All Series | January 2017
ERROR
FMI
J1587
operational signal is in
range normal range
2. Temperature
is above 100dgC
during 18000s
Deactivate low:
1. The sensor
signal is in
normal range
2. Temperature
is below 100dgC
Activate
medium: 1. The
sensor signal is
in normal range
2. Temperature
above 120dgC
during 600s
Deactivate
medium: 1. The
sensor signal is
in normal range
2. Temperature
is below 120dgC
Activate high:
1. The sensor
signal is in
normal range
2. Temperature
is above 140dgC
during 30s
Deactivate
high: 1. The
sensor signal is
in normal range
Temperature is
below 140dgC
Activate: The
sensor signal is
Voltage below below normal
FMI4 normal or range
shorted low Deactivate: The
sensor signal is
in normal range
Activate: The
sensor signal is
Current below above normal
FMI5 normal or range
open circuit Deactivate: The
sensor signal is
in normal range
Activate: The
difference
between clutch
positions
indicated by the
Data erratic,
sensor signal
FMI2 intermittent or
(SEPoC) and the
incorrect
inverted sensor
signal ( SEPoC
INV) is to large
and both signals
is within normal
CONDITION SYMPTOM
sent
Symbol for high
gearbox oil
temperature is lit
Medium:
Yellow lamp is
sent
Symbol for high
gearbox oil
temperature is lit
High:
Red lamp is sent
Symbol for high
gearbox oil
temperature is lit
Yellow lamp is
sent
Yellow lamp is
sent
Yellow lamp is
sent
Reduced clutch
performance
Reduced
gearbox comfort
at start and
marshalling
Gear changes
are slow
COMMENT
the vehicle has oil
temperature sensor
functionality installed
The PID 33 fault code
should not be set if there is
an active fault code on the
clutch position sensor
supply (PPID 54)
The clutch position sensor
has four connectors: one
supply, one ground and two
connectors for the sensor
signal. With correct input
the input voltage of the
sensor signal, the inverted