PREVOST H3-41 Maintenance Manual page 812

SECTION 18b: X3 SERIES BODY
FIGURE 130
5. Open the door and perform a final tightening
to the items indicated with arrows (FIGURE
131).
FIGURE 131
Transversal adjustment
6. Once closed, the door surface must be even
with the adjacent steel panel.
Tolerance is 3/64" (1mm)
128
PA1621 Maintenance Manual All Series | Revised Sept 2019
FIGURE 132: USE A RULER (SHOWN IN BLACK) TO
CHECK THAT SURFACES ARE EVEN
7. Use the pin to adjust the door so it is even
with the adjacent steel sheet. Screw or
unscrew the pin as required and then apply
final tightening to the jam nut (FIGURE 133).
FIGURE 133
8. The R.H. side engine access door must
exceed the engine compartment by 5/32"
(4mm).
Tolerance is ±3/64" (±1mm)
FIGURE 134