PREVOST H3-41 Maintenance Manual page 863

1. Perform the first lift as instructed in
paragraph 2.2.1 if not already done.
2. Install regular axle forks onto tow bar
fork holders.
TALL
Pre-adjust spacing between axle
forks
Minimum spacing: 25 inches
Maximum spacing: 33 inches
3. Lower the stinger arm to position the
axle forks under the front axle hoisting
points (Figure8 and Figure9).
4. Lift the tow bar until the axle forks grab
the front axle I-beam at the hoisting
points (Figure 44).
5. Raise the front of the vehicle.
6. Install a jack stand under the stinger
arm for support and safety purposes
and then lower the stinger arm so it
rests on the jack stand (Figure 47). The
Writer:
FL
FIGURE 43
REGULAR
FIGURE 44
FIGURE 45
MI18-18
Page 19 / 30
<QF7720955 rev 7>