Xenon Bulbs Replacement - PREVOST H3-41 Maintenance Manual

SECTION 06: ELECTRICAL
FIGURE 78: TURN SIGNAL LIGHT
2. Disconnect the electrical harness connector
from the light module.
3. Unscrew the 4 mounting fasteners and
replace the light module.
4. Install wiring connector on back of new turn
signal module.
NOTE
Make sure headlamps assembly is properly
positioned into its housing before securing
using fixing screws.
16.1.5

Xenon Bulbs Replacement

The outer lamps (low beam) of each headlamps
assembly may be equipped with the optional
Xenon lamps. These lamps improve visibility
and provide better lifespan.
Bulb Removal and Replacement
1. Pull the release handle located inside the
front service compartment to tilt down the
entire bumper assembly.
82 PA1621 Maintenance Manual All Series | Revised Sept 2019
FIGURE 79: XENON HEADLAMP
2. Remove connector from headlamp bulb by
turning counterclockwise.
3. Unscrew the three Phillips head screws
(Figure 79) pull the retainer and bulb out.
CAUTION
To avoid breaking the bulb, make sure the
socket is in proper position against the stop.
4. Install the new bulb by reversing the
previous steps and make sure the connector
stopper is in place (Figure 80).
FIGURE 80: CONNECTOR STOPPER