PREVOST H3-41 Maintenance Manual page 957

REMOVING THE BELTS
1) Remove the two drive belts.
M12 MOUNTING SCREW REMOVAL
2) While holding the hexagonal part of the
rotor with a wrench, loosen and remove
the M12 mounting screw (3, Figure 2).
EXTRACTOR TOOL
3) Screw extractor tool #680888 in the
straining washer (3a, Figure 2).
Do not use a standard M16 screws unless
the tip of it has been rounded off, failing to
do so may damage the shaft end bore or
threads where the M12 screw is fastened
Writer:
EL
REMOVING THE ROTOR
to
EXTRACTOR TOOL # 680888
MI18-37
Page 5 / 14
<QF7720955 rev 7>