PREVOST H3-41 Maintenance Manual page 190

SECTION 06: ELECTRICAL
Unlocking the secondary lock
To unlock the secondary lock on these housings, a simple
solid commercial ball pen is sufficient. The ball pen has to
be inserted perpendicularly according the image, between
the locking latch of the housing and the secondary lock
block. Then it will be pushed with care until the opening is
felt (a "click" sound can be heard).
Extracting the contacts from housings
To extract contacts, the secondary lock has to be in the
unlock position. The tool has to be inserted from connection
side into the cavity of housing up to the stop; the contact
will be unlocked thereby. Keep the tool in that position and
then take the contact out by pulling on the cable. Note: Do
not pull the cable before unlocking the contact; on the other
hand by pressing the cable gently against the cable outlet
direction the unlocking procedure will be facilitated.
Multiplex modules
VECR / VECF
06627
26 PA1621 Maintenance Manual All Series | Revised Sept 2019
Connector type
06632
BUSSMAN
EXTRACTOR/TOOL: Prevost 568103
Contact removal
EXTRACTOR/TOOL: Prevost #682256
(Packard 12094429)
Remove the terminal by disengaging the
flexible lock tab on the terminal. Gently
remove the terminal from the connector by
pulling on the wire.