PREVOST H3-41 Maintenance Manual page 773

SECTION 4 ENGINE AIR INTAKE PANEL INSTALLATION
4.00 Make sure that sealing of structure has been performed
properly
4.05 Prepare vehicle surface as for side panel.
4.10 Prepare air intake panel as for side panel
4.15 Install foam tape 1/8" X ¼" onto structure, as shown in
picture
4.20 Install foam tape 1/16" X ¼ onto air intake panel pleat
Apply a bead of 252 onto structure as per picture
4.25
Important: Make sure bead is continuous
Triangular bead: 10mm x 8mm
4.30 Install panel onto structure
4.40 Use a brush to compress Sika bead
Refer to step # 2.00
Refer to step # 2.05
Use a jig to make sure that panel is lined up with
engine door tubing.
PA1621 Maintenance Manual All Series | Revised Sept 2019
SECTION 18b: X3 SERIES BODY
89