PREVOST H3-41 Maintenance Manual page 729

 Position body panel onto door frame and
compress with your hands. Use a ruler.
 Check body panel flatness using a 2-foot
ruler (must be within 2mm).
 Check proper power window sliding inside
window frame.
 If applicable, remove excess of Sika
adhesive all around door frame using Sika
208.
 From the inside of the door, apply some
Sika 221 between door body panel and
frame and on welding spots as per figure.
 Apply some #680066 glue inside fiber
glass groove and fix power window wiper.
NOTE
Anti-friction side must be on glass side.
 From inside the door, apply some Sika
252 at the corners of window wiper.
 Apply some #680066 glue inside finishing
panel groove and fix power window wiper.
NOTE
Anti-friction side must be on glass side.
PA1621 Maintenance Manual All Series | Revised Sept 2019
SECTION 18b: X3 SERIES BODY
45