Side Panel For Vehicles Fitted With Slide-Out; Side Crest - PREVOST H3-41 Maintenance Manual

using a straight edge. Take measurements with a
ruler.
For the structure
installation of a ridged side panel, refer to
procedure SAV00027.
For gluing of ridged side panels, refer to
procedure SAV00028.
For sealing the side panels' upper portion, refer
to procedure SAV00030.
For gluing of horizontal finishing molding, refer to
procedure SAV00208.
10.7.2 Side Panel for Vehicles Fitted With
Slide-Out
 Removal
Refer to paragraph 7.7.1 for procedure.
preparation before
towards the inside.
the
CAUTION
Because most junction panels are only riveted
and not spot welded, be careful when
removing a side panel not to damage adjacent
panels.
For the slide-out junction panel preparation
before the installation of a ridged side panel,
refer to procedure SAV00031.
For gluing of ridged side panels on vehicles fitted
with slide-out, refer to procedure SAV00029.

10.7.3 Side Crest

o Clean vehicle surface using anti-silicone
where the side crest and stickers will be
applied.
Using hands apply and compress side crest.
o
o Apply required stickers.
PA1621 Maintenance Manual All Series | Revised Sept 2019
SECTION 18b: X3 SERIES BODY
143