PREVOST H3-41 Maintenance Manual page 722

SECTION 18b: X3 SERIES BODY
Install and center window onto door frame.
•
Using your hands, compress window.
Discard waste according
•
environmental regulations, use dangerous
waste containers.
Apply masking tape before applying Sika
•
glue to protect paint and adjacent surfaces
during surface treatment
Body Panel
For the removal of entrance door body panel,
you will need:
Pneumatic hammer tool (Zip Gun);
Razor sharp window scraper;
• Open entrance door.
Remove interior finishing panels to access
•
rub rail fixing bolts, then remove rub rail.
• Remove door lock and interior lighting.
Using the "Zip Gun", cut Sika bead located
•
¼ inch (7-8 mm) from each body panel
edge.
NOTE
Wear ear plugs during this operation.
Separate body panel from door.
•
• Using a razor sharp window scraper, remove
from door frame Sika bead and double-face
self adhesive tape residue.
• Using a scratch pad "Scotch Brite", scratch
the perimeter of the door frame where the
adhesive will be applied.
• Clean door frame again using anti-silicone.
38
PA1621 Maintenance Manual All Series | Revised Sept 2019
•
to applicable
•
•
•
•
Apply some Sika 206 G+P onto door frame.
Using a scratch pad "Scotch Brite", scratch
the perimeter of the body panel where the
adhesive will be applied.
Clean body panel using anti-silicone.
Apply some Sika 206 G+P onto body panel.
Apply 1/8 x1/4 double face self-adhesive
tape onto door frame.
NOTE
Leave some space at the bottom (50mm) for
water dripping