PREVOST H3-41 Maintenance Manual page 743

FIGURE 50: DOOR INSTALLATION – LATCH SYSTEM
A - BOLT
B - BELLEVILLE WASHER
C - STRIKE PLATE
D - SPACER
E - PIN
F – LOCK NUT
G - BELLEVILLE WASHER
H - PLATE
FIGURE 51: USE A CABLE TIE TO KEEP SECONDARY
LOCK DEPRESSED DURING ADJUSTMENT
FIGURE 52: HINGES
A – ENGINE R.H. SIDE ACCESS DOOR
B - BOLT
C - BELLEVILLE WASHER
D - BOLT
E - WASHER
F –SPACER
G - NUT
Vertical adjustment
2. Make sure bolts A are tight (
FIGURE 53
3. Compare the lower edge of the door level
with the lower edge of the rear fender. The
door should be flush with the fender
(FIGURE 54).
Tolerance is ± 3/32" (± 2mm)
PA1621 Maintenance Manual All Series | Revised Sept 2019
SECTION 18b: X3 SERIES BODY
FIGURE 53
).
59