Lamp Removal And Replacement; Fog Lights; H3 Models Fog Light Removal And Replacement - PREVOST H3-41 Maintenance Manual

SECTION 06: ELECTRICAL
V.I.P. model, a dashboard-mounted rocker
switch may be actuated to cancel this system in
special situations.
Two additional halogen sealed-beam units are
installed on rear electrical compartment door
(R.H.) and radiator door. These lights are used
as docking lights and both will illuminate
automatically when reverse range is selected to
facilitate back-up or docking procedure.
On the V.I.P. model, these lights do not operate
automatically when
selected, but by means of a dashboard-mounted
rocker switch. When actuated, the docking as
well as the cornering
Furthermore, a "Low docking" switch, also
located on dashboard, allows the use of the
docking and cornering lights at a lower intensity
when the docking switch is actuated.
16.8.1

Lamp Removal And Replacement

Both docking and cornering sealed-beam units
can be changed in accordance with the following
procedure:
1. Remove the two "Phillips" screws attaching
the retaining ring.
2. Disconnect the light unit connection.
3. Remove the lamp.
4. Position new lamp.
5. Connect and position the light unit.
6. Finally, install the retaining ring and screw.
16.9

FOG LIGHTS

Optional fog lights can be mounted on the
vehicle to give the driver better visibility in foggy
weather, or to improve the range of vision just
ahead of the coach.
16.9.1 H3 models Fog light removal and
Replacement
1. Lower the bumper by pulling the release
handle located in the front electrical and
service compartment.
2. Disconnect the wiring and cut the cable ties.
3. Remove the screws that supports the fog
light subassembly on the bumper support
(Figure 97).
90 PA1621 Maintenance Manual All Series | Revised Sept 2019
the reverse range
lights illuminate.
is
FIGURE 97: FOG LIGHT SUBASSEMBLY DISMOUNT
4. Remove the screws (2) that supports the fog
light pod, keep screws and lockwashers.
FIGURE 98: FOG LIGHT REMOVAL
5. Discard the defective fog light pod.
6. Install a new cable tie on the fog light
support.
FIGURE 99: CABLE TIE INSTALLATION