RING CABLE LUGS
Figure 16: Cable lugs must be closed type, crimped or welded.
Ring cable lugs should not be distorted.
•
•
Ring cable lugs should not suffer strains that can deform.
Ring cable lugs must be installed with smooth washers and nuts to prevent damage to the cable lug
•
when tightening.
Figure 17: Power cable shouldn't be bent just next to the cable lug. Angled cable lugs are used to avoid
mechanical stress.
Figure 18: When several terminals are connected on a single stud terminal, the largest cable lug must be
placed first, followed by the second larger and so on. Cable lugs should be distributed around the stud
terminal in a way that no cable lug is distorted when tightening the nut.
MI15-24B / Page 8 / 14
QF7720956 rev3>