Second Lift- Using I-Beam Front Axle As Lifting Point For Towing - PREVOST H3-41 Maintenance Manual

11. Raise the stinger arm and remove
the support jack stand.
12. Lower the vehicle. The front tires
should be 7" to 8" above the ground
before the tow can proceed.
13. Use bungee cords to support the
safety chains (Figure 40).
14. If required, use the appropriate jig to
assure that the highest point on the
vehicle does not exceed the maximum
allowable height for towing (Figure 41).
15. Make sure the parking brake is
released before moving the vehicle.
16. Observe safety
towing.
Avoid sharp turns where possible as
safety chains may rub and damage the
front bumper (Figure 42)
2.2.3

Second Lift- Using I-Beam Front Axle as Lifting Point for Towing

This method uses the I-beam axle as lifting points for towing (Figure8 and Figure9).
Writer:
FL
FIGURE 40
precautions when
FIGURE 41
FIGURE 42
MI18-18
Page 18 / 30
<QF7720955 rev 7>