PREVOST H3-41 Maintenance Manual page 809

FIGURE 117: USE A CABLE TIE TO KEEP SECONDARY
LOCK DEPRESSED DURING ADJUSTMENT
FIGURE 118: HINGES
A – ENGINE R.H. SIDE ACCESS DOOR
B - BOLT
C - BELLEVILLE WASHER
D - BOLT
E - WASHER
F –SPACER
G - NUT
Vertical adjustment
22. Make sure bolts A are tight ( ).
FIGURE 53
PA1621 Maintenance Manual All Series | Revised Sept 2019
SECTION 18b: X3 SERIES BODY
FIGURE 119
23. Compare the lower edge of the door level
with the lower edge of the rear fender. The
door should be flush with the fender
(FIGURE 54).
Tolerance is ± 3/32" (± 2mm)
FIGURE 120
24. If the vertical position is out of tolerance,
release the locking plate (Figure 56) and
rotate the door
provided on the inner side of the door, at the
attachment points between the arm and the
door ( ).
FIGURE 55
Tighten the locking plate nut to 14 lb-ft (19
Nm) to preserve adjustment.
Perform the adjustment with the lower
adjustment point preferably.
using the adjustment
125