Evaporator Door Adjustment; Latch Mechanism Adjustment; Main Power Compartment - PREVOST H3-41 Maintenance Manual

31. EVAPORATOR DOOR ADJUSTMENT

1. Open the door.
2. Loosen nut (1, Figure 76).
3. Move part as shown in figure for "LEFT or
RIGHT" adjustment.
4. Tighten nut (1, Figure 76).
5. Loosen nut (2, Figure 76). Hinge allows the
door to be shifted "IN or OUT".
6. Adjust the door in accordance with the
required distance between exterior finishing
parts (Figure 52).
7. Loosen screws (3, Figure 76). Screws allow
the door to be shifted "UP or DOWN".
8. Adjust the door position according to the
distance required between exterior finishing
parts (Figure 52).
41,2 ±
3
FIGURE 76: EVAPORATOR DOOR

32. MAIN POWER COMPARTMENT

To adjust the main power compartment door:
1. Loosen nut (1, Figure 77).
1
mm
2
2
PA1621 Maintenance Manual All Series
SECTION 18a: H3 SERIES BODY
9. Tighten the screws.
Check that the door swings freely and closes
properly. It may be necessary to adjust the door
latch to get proper fit and operation.

31.1 LATCH MECHANISM ADJUSTMENT

1. To adjust the latch mechanism and the
striker pin:
2. Open the door to access the striker pin.
3. Loosen slightly the striker pin.
4. Using a hammer, adjust the striker pin to
center it in the door latch mechanism.
5. Tighten the striker pin. Check door fit and
operation.
8 ± 2 mm
1
41 ± 2 mm
18198
| 69
Revised Sept 2019