PREVOST H3-41 Maintenance Manual page 740

SECTION 18b: X3 SERIES BODY
9.3 ZONE 3
FIGURE 45: ZONE 3
9.3.1 Rear Cap
The fiberglass rear cap does not need any
maintenance except painting as needed. It is
held in place with adhesive. If ever it has to be
replaced, take an appointment at a Prevost
service center near you. For minor damages,
refer to Paragraph 4 "Common Fiberglass
Repair Procedure" and Paragraph 5 "Common
Painting Procedure".
9.3.2 Engine Compartment Door
The engine compartment door may be adjusted
for proper fit by untightening support bolts:
NOTE
Consult the "BODY PANEL AND WINDOW
SPACING DIAGRAM" for proper door gaps
adjustment. (Figure 86)
1. To adjust the door VERTICAL position,
loosen the bolts (4 on each side) holding the
door supporting arm and gas springs bracket
to the vehicle structure (Figure 46).
2. To adjust the door LATERAL position,
loosen the bolts (3 on each side) holding the
door supporting arm and gas springs bracket
to the door (Figure 46).
3. Adjust the door FORE & AFT position by
screwing/unscrewing the rubber door stops
on each side of the door opening (Figure
46).
56
PA1621 Maintenance Manual All Series | Revised Sept 2019
4. Check that the door swings freely and close
properly. It may be necessary to adjust the
door latch to get proper fit and operation.
To adjust the latch mechanism and the striker
pin:
1. Open the door to access the striker pin.
2. Slightly loosen the striker pin.
3. Using a hammer, adjust the striker pin to
center it in the door latch mechanism.
4. Tighten the striker pin.
5. Check door fit and operation.
FIGURE 46: ENGINE COMPARTMENT DOOR
18626
18633_1