Door Lubrication; Door Latch Mechanism; Driver's Power Window; Power Window Removal - PREVOST H3-41 Maintenance Manual

WARNING
Wear rubber gloves and do not smoke when
cleaning.
5. Peel of protective paper from the seal.
Position the seal in order to leave ¼" (6 mm)
from the upper molded edge of the door and
3/16" (4,5 mm) from the sides and lower
molded edges of the door.
6. Progress slowly all around the door.
7. Cut the seal and glue both ends with
LOCTITE 414 glue.
8. To assure bonding, press a small roller on
top of the new seal.

11.7 DOOR LUBRICATION

Part Lubricant
Latches
Low
temperature
Upper door
grease
catch
Door locking
White grease
mechanism
Key hole
Low viscosity
Hinges

11.8 DOOR LATCH MECHANISM

Generally, when the
malfunctions, a number of causes may be
responsible for this
procedure will correct this situation. It is best to
remove the protective cover and to look for
binding, used or bent parts. Operate the latch
mechanism and try to find where any binding
occurs. Replacing a part or slightly bending a
rod should be enough.
global understanding of the mechanical activity
will generally lead you to the cause of the
problem, and ultimately to an easy repair.
Frequency
Every six months
Every six months
Every six months
oil
latch mechanism
situation. No single
Remember, having a
PA1621 Maintenance Manual All Series
SECTION 18a: H3 SERIES BODY
FIGURE 21: ENTRANCE DOOR (VIP, TYPICAL)

12. DRIVER'S POWER WINDOW

To replace window or motor, the whole assembly
must be removed. The following instructions
refer to Figure 22.

12.1 POWER WINDOW REMOVAL

1. Raise the driver's power window.
2. Set the battery master switch to the OFF
position.
3. The window must be held in upper position.
To do so, use duct tape to hold it in place.
4. Gain access to
mechanism. Dismount the driver's area
lateral control panel and left interior trim. It
may be required to remove the driver's seat
and dashboard panel.
5. Unfasten bolts (item 1) fixing the window to
the lifting mechanism (actuator).
6. Remove the three bolts (item 2) holding the
motor support and actuator assembly in
place.
7. Detach the plastic water protection shield
and remove the assembly by slipping it
under the vehicle structural members.
8. Dismount the window support and lower the
window completely to release it from its
guides.
|
Revised Sept 2019
18440
the power window
31