SECTION 01 : ENGINE
FIGURE 14: TYPICAL X SERIES ENGINE COMPARTMENT
2.7 POWER PLANT ASSY. INSTALLATION
To install a power plant assembly, follow the
same procedure as in "Power Plant Assembly
Removal" except in reverse order, then proceed
with the following:
1. Torque the power plant cradle mounting
bolts.
TORQUE: 190 lb-ft (258 Nm)
2. Remove bolts B and D. Untighten bolts A
and C then pivot oil cooler as per Figure 15.
Install bolts B and D and tighten all bolts.
22
PA1621 Maintenance Manual All Series | Section 01 revised Feb 2019
FIGURE 15: NORMAL OIL COOLER POSITION