Installation; Operation; Windshield Sunshades; End Of Stroke Adjustment - PREVOST H3-41 Maintenance Manual

4.1.2

INSTALLATION

Place the hub odometer unit over the wheel hub
studs. Replace the lock washers and nuts.
Torque stud nuts.
TORQUE: 110-165 lb-ft (149-224 Nm)
FIGURE 18: HUBODOMETER
4.2

OPERATION

The hub odometer is calibrated for a specific
wheel size (diameter). Wheel rotation causes a
mechanism inside the hub odometer to record
distance after a predetermined number of
rotations. The unit should be serviced at a
competent speedometer repair facility.
NOTE
Do not use paint, solvent or thinner on hub
odometer face or on plastic hubcaps. Do
not weld on hub odometer.
5. ELECTRONIC DESTINATION SIGN
(OPTIONAL)
5.1.1 DESCRIPTION
The destination sign is located at upper front of
the vehicle.
To change the destination, depress the selecting
switches until the desired destination appears in
the LCD display.
SECTION 23A: ACCESSORIES - H3 SERIES
NOTE
LCD display may be located at the back of the
destination sign (series 600) or on the vehicle
modesty panel (430 series). Refer to the
corresponding supplier's
more information regarding operation and
maintenance of the destination sign.
NOTE
A data file must be loaded into the destination
sign control unit before operating the system
on the road. Insert the supplied USB key in the
display USB port to automatically start the
process.
23027
FIGURE 19: DESTINATION SIGN LCD DISPLAY (SERIES
600 SHOWN)

6. WINDSHIELD SUNSHADES

Two
installed in the driver's area at the top of the
windshields.
Control buttons are located on the steering
wheel and the dashboard to operate sunshades
individually.
"Controls and Instruments" chapter for more
information.
Pulling down manually on the sunshade may
damage the mechanism.
6.1
PA1621 Maintenance Manual All Series | Jan 2020
operating manual
23123-1
electrically operated
Refer to Operator's
CAUTION

END OF STROKE ADJUSTMENT

for
sunshades are
Manual:
17