PREVOST H3-41 Maintenance Manual page 706

SECTION 18b: X3 SERIES BODY
In the event you sand through to the gelcoat
surface you should prime the area with Standox
"Non Stop Fill Primer (ST-11000)".
If you sand through to metal surface, first prime
with Standox "Etch Primer (ST-11858)" then with
Standox "Non Stop Fill Primer (ST-11000)".
CAUTION
Be sure to heed all paint manufacturer's
recommendations, especially concerning paint
dilution and application.
8.3 PAINTING
The standard paint used on the exterior of the
vehicle is Standox Basislack. It is a high gloss
polyurethane enamel
exposure to extreme conditions. Other types of
paint may be called for as options by owner but
are not dealt with in this section.
8.3.2 Surface Preparation and Paint Application
Surface Preparation
Cleaning
Priming
Basecoat
Clearcoat
NOTE
Product listing above is based on factory applied products. Local VOC (Volatile Organic Compound)
regulations may vary, consult your paint supplier and use a VOC compliant product that matches the
factory recommendations if required to do so.
22
PA1621 Maintenance Manual All Series | Revised Sept 2019
finish designed
Aluminum and / or
Stainless Steel
Sand using P-150 grit sandpaper.
It is recommended to sandblast
rivets and panel edges
OLIMAG 35-70 blast media.
STANDOX silicone remover ST-16203
STANDOX Reactive Etch Primer
ST-13908
* Wait 30 minutes then apply
STANDOX HS primer ST-15161
Refer to paint scheme or coach record for proper color code
and paint brand.
We recommend using the same paint brand to ease color
matching.
Axalta Imron Clear 8430 S
Allow 16 hours for drying
8.3.1 Safety
Care should be exercised in storing, handling,
mixing, and applying paint and chemicals listed
in this manual. The topcoat, primer, solvent,
catalysts, accelerators, and cleaners are highly
volatile and/or toxic if not properly used. Observe
all safety instructions marked on the different
packaging, as well as the following:
1. Do not smoke in the paint room or in adjacent
area exposed to residue fumes.
2. Wear respirators approved by the governing
safety and health regulations.
3. Maintain adequate ventilation at all times.
4. Dispose of any leftover paint mix properly.
for
5. Wear rubber gloves, rubber apron, and face
shield during all phases of paint and chemical
handling
Fiberglass
Sand using P-180 or
P-240 sandpaper.
with
STANDOX
Füllprimer
(68-2973)
Comments
Do not use paint remover
over aluminum or fiberglass.
Non-Stop Refer to product Technical
ST-11000 Data sheet for proper mixing
Refer to product Technical
Data sheet for proper mixing
Refer to product Technical
Data sheet for proper mixing