PREVOST H3-41 Maintenance Manual page 709

FIGURE 15: REAR VIEW MIRROR (RAMCO)
Adjustment
•
At the base of the mirror arm, loosen the
mounting bolt to swing arm in or out.
To pivot the mirror head, loosen the setscrews
on each side of the ball stub at the base of the
mirror head to facilitate the adjustment.
Disassembly
•
At end of mirror arm, loosen the setscrews to
relieve tension on the ball stem. Remove the ball
stem from the arm.
Remove the four screws fastening the mirror
arm base to the coach.
Assembly
•
Mount the mirror arm base to the coach. Insert
the ball stem into the mirror arm and tighten the
socket setscrews.
NOTE
Position the ball cup halves so the joint
between them lies on the centerline of the arm.
Ensure that the setscrews are not on the joint
between the cup halves.
Replacement of Mirror Glass
•
Remove the broken glass.
Position new glass in mirror head and press to
lock the Velcro in place.
Heated / Remote Controlled Rear View
•
Mirrors
Heated/remote controlled external rear view
mirrors may be provided to prevent the mirrors
from frosting up in cold weather.
The remote controlled external rear view mirrors
attach to support arms using a pivot collar
secured by setscrews. Loosening the setscrews
allows the whole head assembly to turn on the
support arm for initial adjustment. A mounting
bolt and washer hold the arm support to the
mounting bracket. The arm support can be
moved to position the mirror head into or away
from the coach body.
The mirror heat switch is located to the left of the
driver on the dashboard. This switch must be
18398A
activated before the mirror heating element will
energize. Once energized, the mirror heating
element is kept at a sustained temperature
(between 60-80°F) by a thermostat. Refer to
wiring diagram
publication box.
CAUTION
Do not attach stick-on type convex mirror
accessories to the heated mirror glass. This
could impede uniform heat distribution on the
mirror surface which could break the mirror.
Mirror Control
•
The remote control pointer knob(s) for the
mirror(s) is (are) mounted on the L.H. side
control panel. The harness to the mirror head
runs through the arm support. The remote motor
is mounted to the mirror head behind the mirror
glass.
Turn pointer knob to the left for mirror head
adjustments and to the right for convex mirror
adjustment, then push down on either of the
button's (4) sides to adjust the selected mirror
viewing angle.
Disassembly
•
At end of mirror arm, loosen the setscrews to
relieve tension on the ball stud. Remove the ball
stud. Remove the ball stud from the arm and
gently pull the harness out until the connector is
exposed.
Remove the four screws fastening the mirror
arm base to the coach. Slide the harness free of
the mirror arm base.
Assembly
•
PA1621 Maintenance Manual All Series | Revised Sept 2019
SECTION 18b: X3 SERIES BODY
annexed in the technical
25