PREVOST H3-41 Maintenance Manual page 715

9.1.6.4 Installation of Rubber Extrusion and Windshield
CAUTION
The black rubber extrusion securing the windshield in the opening fits correctly in only one position.
Find the correct position of the rubber extrusion now, and make reference marks with a china marker to
avoid searching for the correct position later in the procedure.
1. Clean the windshield opening sealing surfaces with anti-silicone and let dry.
2. Apply a 1/8" bead of black Simson adhesive #684685 to all four corner of the gasket in the groove
outside corner as illustrated in Figure 20. Do this before placing gasket on vehicle structure to control
quality and continuity of bead. This method helps achieve a watertight installation.
3. Place gasket on vehicle and secure the upper sections with tape
4. Wait for Simson adhesive to bond Install windshield as per paragraph 9.1.6.3: "Windshield Installation"
FIGURE 20: APPLICATION OF BLACK ADHESIVE
PA1621 Maintenance Manual All Series | Revised Sept 2019
SECTION 18b: X3 SERIES BODY
31