PREVOST H3-41 Maintenance Manual page 734

SECTION 18b: X3 SERIES BODY
 Apply masking tape on each side of
vertical molding. Apply Sika 252 to fill the
gap between molding and windows.
 Smooth down the joint with finger.
 If required, clean surfaces using Sika 208.
9.1.10 Front Cap
The fiberglass front cap does not need any
maintenance except painting as needed. It is
held in place with adhesive. If ever it has to be
replaced, make an appointment at a Prevost
service center near you. For minor damages,
refer to paragraph 7 "COMMON FIBERGLASS
REPAIR PROCEDURE"
"COMMON PAINTING PROCEDURE".
50
PA1621 Maintenance Manual All Series | Revised Sept 2019
and paragraph 8