Rear Fender; Engine R. H. Side Access Door - PREVOST H3-41 Maintenance Manual

SECTION 18b: X3 SERIES BODY
10.4 ZONE 4
FIGURE 115: ZONE 4

10.4.1 Rear Fender

On X3-45 VIP vehicles, rear fenders are hinged
for maintenance on brakes and suspension.
Each rear fender panel has two mechanical
spring loaded holding devices fixing it to the
vehicle's structure. Push the spring type rod
sideways to disengage the lock.
For the installation of rear fender body panel,
refer to procedure SAV470046.

10.4.2 Engine R. H. Side Access Door

Engine R. H. side access door may be adjusted
for proper fit. To do so, follow the steps below:
21. To adjust the position, the door must be free
to move without any restriction. For this
reason, remove pin E and strike plate C
(Figure 50).
Temporarily secure the secondary lock in the
depressed position with a cable tie so it does
not interfere with adjustments. Remove
cable tie once completed.
124
PA1621 Maintenance Manual All Series | Revised Sept 2019
FIGURE 116: DOOR INSTALLATION – LATCH SYSTEM
A - BOLT
B - BELLEVILLE WASHER
C - STRIKE PLATE
D - SPACER
E - PIN
F – LOCK NUT
G - BELLEVILLE WASHER
H - PLATE