PREVOST H3-41 Maintenance Manual page 860

1. Perform the first lift as instructed in
paragraph 2.2.1 if not already done.
2. Place the axle forks on the tow bar
fork holders (Figure 34).
Use 3" to 4 ½" mouth axle forks
preferably
REGULAR
Pre-adjust spacing between axle forks
to = 37 inches
3. Lower the tow bar and position under
the front tow eye pads.
4. Adjust fork holder's position and hand
guide the forks into each front tow
eye. (Figure 35)
5. Lift the tow bar until the axle forks fit
snugly into the
(Figure 35).
6. Raise the front of the vehicle.
7. Install a jack stand under the stinger
arm for support and safety purposes
and then lower the stinger arm so it
rests on the jack stand (Figure 36).
The tow cans or blocks can be
removed from under the front axle
wheels.
Writer:
FL
FIGURE 34
front tow eyes
FIGURE 35
FIGURE 36
MI18-18
Page 16 / 30
<QF7720955 rev 7>