PREVOST H3-41 Maintenance Manual page 771

B) Position side panel in front of vehicle structure
C) Perform final adjustment to make sure that side
panel is true and square
D) Sand rear of side panel 2" wide
E) Perform tig spot welding (1" apart)
3.20 A) Install pulling equipment at the other end of side
panel
B) Make a final adjustment in height
C) Sand front of side panel 2" wide
D) Pull side panel so that panel moves 1/8"
E) Perform tig spot welding
3.30 Remove pulling equipment
3.40 A) Remove protective film from double-face self-
adhesive tape.
Section A-A
–
–
Quantity of "tig spot": 30 minimum.
Make sure the equipment pulls along the
whole width of side panel
Quantity of "tig spot": 30 minimum.
PA1621 Maintenance Manual All Series | Revised Sept 2019
SECTION 18b: X3 SERIES BODY
Section B-B
30 mm. ± 2 with reference to bottom
tubing
6 mm ± 1 with reference to vertical tubing
87