PREVOST H3-41 Maintenance Manual page 995

4. The left wiper arm final adjustment is made
by adjusting the rod length to 8.46 inches
(215 mm).
5. Install the right wiper arm in its normal
position (in the middle of the windshield).
Refer to paragraph ''Sweep Adjustment''.
6. The right wiper arm final adjustment is made
by adjusting the rod length to 23.54 inches
(598 mm).
7. Check the adjustment on a wet windshield
11.4 WINDSHIELD WIPER MOTORS
11.4.1 Lower Windshield Wiper Motor
Replacement
The lower windshield wiper motor is located at
lower front of the vehicle, behind the defroster
panel. Refer to Figure 34 for motor location.
WARNING
Park vehicle safely, apply parking brake, stop
engine and set battery master switch to the
''OFF'' position prior to working on the vehicle.
1. Remove the two
retaining the defroster panel, and remove
panel.
2. Disconnect wiring
windshield wiper motor.
3. Loosen clamping screw retaining the lever at
the end of the motor driving shaft.
4. Remove the three bolts holding the motor to
the steel plate.
5. Remove the windshield wiper motor (Prevost
#800304), reverse removal procedure to
reinstall.
Phillips-head screws
connector from the
SECTION 23A: ACCESSORIES - H3 SERIES
PA1621 Maintenance Manual All Series | Jan 2020
29