PREVOST H3-41 Maintenance Manual page 67

5. Using a 18mm socket, unscrew three bolts
fastening the starter to the flywheel
housing ( ).
FIGURE 3
6. Detach the starter from the flywheel
housing.
1. If the starter is replaced with a brand new
starter, prepare the new starter as follows
(refer to ).
FIGURE 5
a) Remove the second nut on the ground
terminal (
FIGURE 5
b) Remove the jumper cable connected
to the ground terminal (
c) Make sure that
identified on
FIGURE 5
a torque of 22 lbf-ft.
d) Reinstall the jumper cable to the
ground terminal.
e) Install a nylon tie mount p/n 504013 on
the starter. Refer to
proper location. Secure the nylon tie
mount with one screw p/n 502817
( ).
FIGURE 7
STARTER INSTALLATION
). Keep for later use.
).
FIGURE 5
the three nuts
are tightened to
for
FIGURE 6
MI16-16 / Page 3 / 6
FIGURE 4 : TERMINAL IDENTIFICATION
<QF7720955 rev 2>
FIGURE 3