11. Fine adjustment of the drag link length if required
should be performed exclusively by turning the
adjustment sleeve while preventing the tube and
joint from rotating.
The only part rotating should be the sleeve
To extend, turn the sleeve clockwise.
•
To retract, turn counter clockwise.
•
GENERAL LIMITATIONS OF THE ADJUSTMENT SLEEVE
Do not exceed the following maximum thread lengths
and values.
Max dimension V : 5/8" (16mm) ± 1 thread
•
pitch
Max dimension W : 5/8" (16mm) ± 1 thread
•
pitch
Max dimension X : 1" (25mm)
•
Dimension V and W should be equal (V/W = 1)
•
Writer:
FL
FIGURE 7
FIGURE 8
<QF7720955 rev 7>
MI19-05A
Page 6 / 8