PREVOST H3-41 Maintenance Manual page 782

SECTION 18b: X3 SERIES BODY
PREPARATION OF "TARABUS" FLOOR COVERING
1. Sand under step using "Scotchbrite".
2. Clean using anti-silicone (refer to Section A).
Section A Alcohol or Anti-silicone
3. Allow drying
Mandatory
Before applying any other
product
3. Apply Sika Primer 215 (refer to Section D).
Section D Sika Primer 215
3. Allow drying
Mandatory
Before applying any other
product
PREPARATION OF FIBERGLASS
98
PA1621 Maintenance Manual All Series | Revised Sept 2019
1.
Apply
CHIX cloth
Minimum time : Wait for product to evaporate
After 2 hours: Start cleaning operation again
If surface seems dusty, greasy or with finger marks, start cleaning
operation again.
1.
Shake bottle to mix product
2.
Apply a thin layer
215 Minimum time : 20 minutes
After 2 hours : Remove dust using damp cloth (pure water)
If surface seems dusty, dust using damp cloth.
If surface seems greasy or with finger marks, reactivate with Aktivator.
2.
Dry immediately
Blue cloth
CHIX cloth