Rear Bumper - PREVOST H3-41 Maintenance Manual

 Engine Compartment Door Body Panel
Removal
For the removal of engine compartment door
body panel, you will need:
Pneumatic hammer tool (Zip Gun);
Razor sharp window scraper;
A pair of locking pliers;
Isopropyl alcohol.
o Remove damaged engine compartment
door from vehicle.
o Install the damaged
appropriate support.
Wearing gloves, goggles and ear plugs,
o
pry loose body panel using a "Zip gun" or
lever starting from the edge opposite the
curved side.
o Use the "Zip gun" to detach completely the
stainless steel body panel from door
frame.
CAUTION
Do not damage painted surface.
Use a second person equipped with a pair
o
of locking pliers to pull the body panel as
you cut the Sika bead.
WARNING
Be very careful when pulling the body panel,
somebody could get hurt if the body panel
suddenly detach from the door surface without
notice.
Using the window scraper, remove any
o
Sika bead or self-adhesive tape residue
left on the fiber glass surface.
For gluing of engine
molding, refer to procedure SAV00211.
For engine compartment door body panel
installation, refer to procedure SAV280032.
door onto an
compartment doors
PA1621 Maintenance Manual All Series | Revised Sept 2019
SECTION 18b: X3 SERIES BODY

10.3.3 Rear Bumper

Remove three bolts on each side holding
bumper to vehicle and remove bumper.
To install bumper, reverse the procedure.
FIGURE 114: REAR BUMPER
123