Digi Connect EZ 4 User Manual page 179

Serial port
rs-485
n
Enable termination if you want to enable electrical termination on this serial port:
l
Enable full_duplex if you want to enable full duplex communication on this serial
l
port:
The default is rs-232.
7. (Optional) Set a label that will be used when referring to this port.
(config)>path-paramlabel label
(config)>
8. Set the baud rate used by the device to which you want to connect:
(config)>path-parambaudrate rate
(config)>
9. Set the number of data bits used by the device to which you want to connect:
(config)>path-paramdatabits bits
(config)>
10. Set the type of parity used by the device to which you want to connect:
(config)>path-paramparity parity
(config)>
Allowed values are:
even
n
odd
n
none
n
The default is none.
11. Set the stop bits used by the device to which you want to connect:
(config)>path-paramstopbits bits
(config)>
12. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
Digi Connect EZ 4/4i User Guide
(config)> serial port1 termination true
(config)>
(config)> serial port1 full_duplex true
(config)>
Configure Login mode
179