Table of Contents
Advertisement
Services
Repeat this step to list additional firewall zones.
8. 1. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
2. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Forward location information to a remote host
You can configure location clients on the Connect EZ device that forward location messages in either
NMEA or TAIP format to a remote host.
Required configuration items
Enable the location service.
n
The hostname or IP address of the remote host to which the location messages will be
n
forwarded.
The communication protocol, either TCP or UDP.
n
The destination port on the remote host to which the messages will be forwarded.
n
Message protocol type of the messages being forwarded, either NMEA or TAIP.
n
Additional configuration items
Additional remote hosts to which the location messages will be forwarded.
n
Location update interval, which determines how often the device will forward location
n
information to the remote hosts.
A description of the remote hosts.
n
Specific types of NMEA or TAIP messages that should be forwarded.
n
If the message protocol is NMEA, configure a talker ID to be used for all messages.
n
Text that will be prepended to the forwarded message.
n
A vehicle ID that is used in the TAIP ID message and can also be prepended to the forwarded
n
message.
Configure the Connect EZ device to forward location information:
WebUI
1. Log into the Connect EZ WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
Digi Connect EZ 4/4i User Guide
Location information
534
Advertisement
Table of Contents
