Table of Contents
Advertisement
Wi-Fi
n
n
d. For Short interval, type the number of seconds to wait between scans for access points,
when the signal strength from the access point to which the client is currently connected is
below the Scan threshold.
e. For Long interval, type the number of seconds to wait between scans for access points,
when the signal strength from the access point to which the client is currently connected is
stronger than the Scan threshold.
f. Click to expand Scan frequencies list.
The Connect EZ device has three preconfigured channels that will be scanned for available
access points:
n
n
n
You can delete the preconfigured channels and add additional channels. At least one
channel is required.
g. To delete a preconfigured channel, click the menu icon (...) next to the channel and select
Delete.
h. To add a channel, click Add Scan frequency and select the appropriate channel.
7. Click Apply to save the configuration and apply the change.
Command line
Digi Connect EZ 4/4i User Guide
If the signal strength from the access point to which the client is currently
connected is stronger the Scan threshold, it will use the Long interval to
determine how often to scan for available access points.
If Short interval and Long interval are set to the same value, Scan threshold is
ignored. For example, the default configuration has both Short interval and Long
interval set to 1 second, which means that the device will scan for access points
once per second regardless of the Scan threshold.
Channel 1 (2412 MHz)
Channel 6 (2437 MHz)
Channel 11 (2462 MHz)
Configure a Wi-Fi client and add client networks
252
Advertisement
Table of Contents
