Digi Connect EZ 4 User Manual page 334

Routing
1. Log into the Connect EZ WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > VRRP.
4. For Add VRRP instance, type a name for the VRRP instance and click .
The new VRRP instance configuration is displayed.
5. Click Enable.
6. For Interface, select the interface on which this VRRP instance should run.
7. For Router ID field, type the ID of the virtual router instance. The Router ID must be the same
on all VRRP devices that participate in the same VRRP device pool. Allowed values are from 1
and 255, and it is configured to 50 by default.
8. For Priority, type the priority for this router in the group. The router with the highest priority
will be used as the master router. If the master router fails, then the IP address of the virtual
router is mapped to the backup device with the next highest priority. If this device's actual IP
address is being used as the virtual IP address of the VRRP pool, then the priority of this device
should be set to 255 . Allowed values are from 1 and 255, and it is configured to 100 by
default.
9. (Optional) For Password, type a password that will be used to authenticate this VRRP router
with VRRP peers. If the password length exceeds 8 characters, it will be truncated to 8
characters.
Digi Connect EZ 4/4i User Guide
Virtual Router Redundancy Protocol (VRRP)
334